The drivers then installed "successfully".
I did some research and found that you can disable driver signature enforcement, so I did that.
Initially, it said that the install had failed, but this was due to there being no driver signature associated with the drivers. I then transferred this backup to my actual PC and restored them. I successfully got the game fully working on my virtual machine and then used a piece of software called "Double Driver" to make a backup of the Jungo drivers (the ones that Funkeys installs). Hub is connected" or "Please wait while I check your U.B.".ĮDIT: Okay, so I have tried a new method. I've even tried transferring the entire game and the drivers over from VirtualBox to my main machine, the game ran, but it always either says "Make sure the U.B. I have managed to get the game working on VirtualBox, but unfortunately not on my Windows 10 machine (which I would MUCH prefer). Also, when I run the Setup.exe in compatibility mode for Windows Vista or below, I get an error message (during the installation) that the hardware driver installation has failed! I've been researching for hours and haven't been able to find a workaround. hub in, despite it already being plugged in. However, I'm still a bit concerned about the issue with the patch, I haven't seen anyone else in this thread have the same issue!Ĭlick to expand.Well, my new hub arrived but unfortunately exactly the same thing is happening I get stuck on the screen telling me to plug my U.B. Hub because I assumed the two I have are broken, so the first issue shouldn't be a problem anymore. If you have any suggestions that would be great, I'd love to be able to play this game again!ĮDIT: I have ordered a new unused U.B. Funkeys Installer failed to create the necessary files!". Could it be that my Hubs are broken (they are very old after all)?Īlso, when I have the patch open (on the screen with the picture of the error message) during the installation, after pressing "Install" on the Setup.exe, another window appears saying "The U.B.
I've tried different USB ports, both USB2.0 and USB3.0, I've tried disabling automatic driver installations, I've tried running the Setup.exe in different compatibility modes, but still no luck. I actually have two Hubs, neither of which seem to do anything. When I plug in my Hub, nothing happens except the little noise the computer makes to acknowledge that a USB device has been connected. Everything runs fine until I get onto the "Please plug in your U.B. Hi, I'm currently having some trouble with the initial installation.